Shop

RsTravertin’O®

$19.79$60.61

New RsTravertin’O® has been specifically formulated to provide the artisan with a product that simulates cut, unpolished Travertine. This dimensional, easy to use material can also be used in any number of creative applications. It works extremely well as a base layer when using RsPlaster™ or RsStone®.

Clear
SKU: 000123 Category:
Approved Application Area Walls, Ceilings, Countertops
Application Method Troweled
Clean Up Soap & Water
Approved Climate Rating Interior/Exterior
Consistency (Density) Medium Plaster
Available Sizes & Square Footage 1 Gallon Pail- 101 - 200
32 Oz Pail- <100
Durability Medium Traffic- Withstands normal wear & tear
Finish Texture Sand Grit
Intermix No
Manufacturer Faux Effects International
Product Line Gold Line
Sheen (Finish) Matte (Flat)
Shelf Life 120 - 365 Days
Approved Substrate Primed Drywall, Painted Drywall
Suggested Additives No
  • Always apply two coats of SetCoat® or SetCoat® Clear as a basecoat, especially with RsTravertin’O®.
  • Make sure that the work surface is well sealed by applying two coats of SetCoat® or SetCoat® Clear. Allow to dry overnight.
  • Using a good quality stainless steel trowel, apply a full even coat of RsTravertin’O® to the work surface. For best results apply the product 1/32” to 1/16” thick.
  • Finish trowel in one direction, moving from top to bottom in a vertical motion.
  • While the material is still wet, take a stiff bristle brush, with widely spaced bristles and place it onto the wet material at the top of the work surface.
  • Drag the brush downwards in a vertical motion adding a slight wave to the lines as the brush moves to the bottom of the work piece. Rinse the brush with water after each vertical pass. Allow the RsTravertin’O® to dry for approximately 30 minutes.
  • Once the product has set up (should be able to touch it without the material coming off on your finger) dampen a trowel and apply it to the work surface. Angle the trowel until it is lying almost totally flat on the material.
  • Move the trowel over the work surface in a horizontal direction. Continue to make horizontal strokes over the entire area of the work surface. Remember to keep the trowel flat to the surface. The trowel must be kept clean and wet at all times during this procedure. Wipe the trowel clean and re-wet after each pass.
  • Allow the finish to fully dry. Once dry, sand the finish with a sanding block to obtain a nice flat even surface.
  • Other materials may now be applied for further embellishment of the RsTravertin’O® surface. Glazes and color washes may be used. Thins layers of tinted Rs Water Wax™ or skim coats of RsPlaster will also create beautiful, original finishes.
  • V.O.C. Compliant
  • Low odor
  • Not for use on floors
  • Do not apply in temperatures under 55°F, or in damp, cold or humid conditions.
  • Technical product- training through Faux Masters Studio workshop recommended
Weight N/A

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.