ColorSeal™

$18.33$218.40

ColorSeal™ is a clear easy to use topcoat with very low non-aggressive co-solvents in its chemical makeup. This product is excellent as a barrier and finish coat over glazes, artwork and sensitive color work. It seals the decorative finish without disruption and prepares the surface to accept a tougher, more durable topcoat if needed.

Clear
SKU: 000031 Category:
Approved Application Area Walls, Ceilings, Floors (Wood), Floors (Cement), Floors (Other), Cabinets (Raw), Cabinets (Pre-Finished), Countertops, Plastic Accents (Switch Plate ETC)
Application Method Brushed, Rolled, Sprayed
Clean Up Soap & Water
Approved Climate Rating Interior/Exterior
Consistency (Density) Thin Liquid (Watery)
Available Sizes & Square Footage 5 Gallon Pail- 1501 - 2000
1 Gallon Jug- 301 - 400
32 Oz Jug- <100
Durability Low Traffic- Fragile, apply in areas with minimal wear & tear
Finish Texture Smooth (Paint Like)
Intermix No
Manufacturer Faux Effects International
Product Line Silver Line
Shelf Life 1 -2 Years
Approved Substrate Painted Drywall, Raw Wood, Painted/Pre-Finished Wood, Plastic
Suggested Additives No
  • May be thinned with water up to 20%.
  • Always make a sample to ensure the desired result.
  • Use ColorSeal™ to seal Custom Art Imprints™. Allow Custom Art Imprints™ and Imprint Coat™ to dry for 24-28 hours before applying ColorSeal™. (If less time is available, use SetCoat® Clear (AquaSeal™) instead, coating the Custom Art Imprint™ immediatly after after it has been applied)
  • Make sure the surface is clean and dry.
  • Using a brush, roller or spray unit, apply one coat of ColorSeal™. This product has a tendency to sag if applied too generously. One thin, even coat is usually sufficient.
  • ColorSeal™ takes slightly longer to dry than other topcoats (depending on drying conditions).
  • Allow ample drying time before applying a second coat of ColorSeal™, AquaGard™, AquaThane™, or C-500 Urethane™.
  • V.O.C. compliant
  • Not for use on floors
  • Non-Yellowing
  • Flexible when dry
  • Good water resistance
  • Low chemical resistance
  • Store in a cool, dry location to prolong shelf life.
  • Do not apply in temperatures below 55° F or in damp, cold or humid conditions
  • Technical product- training through Faux Masters Studio workshop recomended

ColorSeal™ is used as a pre-sealer over sensitive artwork or glazed surfaces; however it does need to be top coated with AquaThane™, AquaGard™, or C-500 Urethane™.

Weight N/A

Reviews

There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.